
|
|
|
|
|
|
|
|
|
|
| The
Details
Description, Patterns included, Instructions, Battery life. Light patterns are added as we think of them or they are requested by customers. Please check this page for any changes since your last order. |
![]() |
The unit may be used outdoors if the controller box is protected from moisture. ( A baggie and tie wrap may be all that's needed, just make sure the open end of the bag is down. ) The LEDs are sealed to make them rain resistant, but don't submerge them.
The basic firefly mode blinks the LEDs
to imitate real fireflies. A push button allows selection of additional
light patterns.
Operating instructions
To run the firefly pattern simply turn the
power switch on. The unit will run the firefly pattern for about an hour
and then turn off.
After turning off the photocell looks for light followed by dark and turns the unit on when it sees dusk. The lights will then run for about an hour. Turning bright room lights on for a few seconds and then off will start the lights flashing again.
To switch to the other light patterns:
Hold the program button until all LEDs light
and release it. The unit will light just one LED to indicate which pattern
is selected and then run that pattern. To step to another light pattern
push and hold the button until the desired LED lights.
Batteries drain is very small when the lights are off so there is usually no need to switch the unit off. The unit will wake back up in the same program when the program button is pushed or the photocell sees dusk. Release the button as soon as the unit wakes up so it won't step into the next light pattern. Switching the power switch off for several seconds will reset to the firefly mode.
If you have an unusual application that uses most lights 12 or 24 hours a day battery life will be much shorter and you may wish to contact us for a model that can run off an AC powered battery eliminator.
Pattern numbers show which LED will light when selecting patterns with the push button switch.
1 Firefly Blink like fireflies.
Every firefly has a different rate.
2 Setup Turns off all
lights, then turns on each light in order, so you can arrange the lights
in the correct order, 1 through 10, for the chase sequences.
3 Waterfall A random
flowing effect.
4 Single Chase All LEDs
lights in sequence, one by one, about 1 tenth second apart.
5 Wait single chase Chase
Like
Single Chase but waits before repeating.
6 Ambivalent chase You
can see the chase in either direction.
7 Wait Ambivalent chase
waits before repeating.
8 Five chase five lights
chase.
9 Wait 5chase waits before
repeating.
10 Two chase 2 LEDS spaced
5 lights apart chase each other
Twilight Lights, 8460 Mustang Place, Colorado
Springs, Colorado, 80908
Find us on the internet at http://www.twilightlights.com/